Wedge Innovations SmartLevel Manuel d'instructions télécharger pdf (Page 6)

TSD = (Calculated TSD)

SHIFT = (Calculated shift of isocenter in cm)

MED SIM ANG = (Calculated medial simulation angle)

LAT SIM ANG = (Calculated lateral simulation angle)

Note: If the printer does not start printing, it may not be turned on or connected to the

calculator, it may not be connected to AC power through the adapter or the batteries may be

dead. The calculator display screen will be blank. Press the ENTER button to display the

printer output on the calculator display screen.

13b. The calculator displays the following output:

After recording each parameter, press ENTER to move from one output to the next.

SEPARATION = (Measured value entered)

FIELD WIDTH = (Value entered determined by breast size)

CALIPER ANGLE = (Measured value entered)

MACHINE TAD = (Value entered determined by treatment machine)

VERTICAL SIM = (Simulator overhead gantry angle)

RIGHT (OR LEFT) BREAST TX (Message indicates which breast is being treated)

TSD = (Calculated TSD)

SHIFT = (Calculated shift of isocenter in cm)

MED SIM ANG = (Calculated medial simulation angle)

LAT SIM ANG = (Calculated lateral simulation angle)

14. The program then asks:

Press the YES button if you have changes to make and return to step 4 or press the NO button to

continue.

If you are printing, the printer will output the new results.

If you are not printing, the calculator will display the new results.

15. The program then asks:

1 2 3 4 5 6 7 8

Pas de commentaire

Wedge Innovations SmartLevel Manuel d'instructions Page 6