Wedge Innovations SmartLevel Manuel d'instructions télécharger pdf (Page 7)

If you are printing, press the YES button and the printer reprints which breast is

being treated and the information calculated. The program returns you to step

14.

If you are not printing, press the YES button and the calculator displays which

breast is being treated and the information calculated. The program returns you

to step 14.

Press the NO button and the program continues.

16. The program asks:

If you are printing, press the NO button and the program ends with the printed

message "SETUP RESTARTS".

If you are not printing, press the NO button and the program ends with the

message "SETUP RESTARTS" displayed on the calculator screen

Press the YES button and the program continues and calculates the treatment angles based on the

gantry angle convention of the accelerator, which may be different from the simulator.

17. The program asks:

Enter the IEC or Varian convention of your treatment machine. The program accepts only 0 or 180

as possible choices. Press the ENTER button to continue.

If you are printing, go to step 18a

If you are not printing, go to step 18b

18a. The printer output prints the treatment machine gantry angle

entered and the medial and lateral treatment angles.

TX VERTICAL = (Treatment machine overhead gantry angle)

MED TX ANG = (Computed medial treatment angle)

LAT TX ANG = (Computed lateral treatment angle)

1 2 3 4 5 6 7 8

Pas de commentaire

Wedge Innovations SmartLevel Manuel d'instructions Page 7